To help with this, we’ve added a "pause" button that you can use to freeze the count while pulling empty tape. Because it cannot differentiate between parts and empty pockets, you will need to ensure that it begins counting after empty tape has been pulled through and stops counting before it reaches the tail. Part pitch is configurable in either mode, so you can accurately count any part that physically fits through the counter.ĭigging a little deeper, what BeanCounter actually does is count feed holes and divide by the part pitch. It will immediately begin counting your parts using one of two modes: Inventory Mode - Using just one sensor, BeanCounter polls at its fastest rate, allowing you to count long tapes and partial reels very quickly. This feature is useful in kitting contexts where you may be cutting fixed quantities off the end of a full reel. To use BeanCounter, simply turn it on and start pulling tape through. This plugin restricts itself to applying these transformations within a particular account, which you provide.
0 Comments
Leave a Reply. |